System Q; Audio Control - Kenwood KTS-MP400MR Mode D'emploi

System Q

You can recall the best sound setting preset for
different types of music.
1
Select the source to set
Press the [TU/SR] or [CD/CH] button.
2
Select the Sound type
Press the [Q] button.
Each time the button is pressed the sound
setting switches.
Sound setting
Flat
User memory
Rock
Pops
Easy
Top 40
Jazz
• User memory: The values set on the <Audio Control>
(page 11).

Audio Control

1
Select the source for adjustment
Press the [TU/SR] or [CD/CH] button.
2
Enter Audio Control mode
Press the [AUD] button for at least 1 second.
3
Select the Audio item for adjustment
Press the [FM] or [AM] button.
Each time the button is pressed the items that
can be adjusted switch as shown below.
4
Adjust the Audio item
Press the [4] or [¢] button.
Adjustment Item Display
Bass Center Frequency*2 "Bass F"
Bass level "Bass"
Bass Q Factor*2 "Bass Q"
Bass Extend*2 "Bass EXT"
Middle Center Frequency*2 "MID F"
Middle level "Middle"
Middle Q Factor*2 "Middle Q"
Treble Center Frequency*2 "TRE F"
Treble level "Treble"
Display
"Flat"
"User"
"Rock"
"Pops"
"Easy"
"Top40"
"Jazz"
5
Range
60/70/80/100 or 150 Hz
–8 — +8
1.00/1.25/1.50/2.00
ON/OFF
0.5/1.0/1.5/2.0 kHz
–8 — +8
1.0/2.0
10.0/12.5/15.0/17.5 kHz
–8 — +8
Balance "Balance"
Fader "Fader"
Sub woofer level*1 "SW Level"
Front High Pass Filter*2 "HPF F"
Rear High Pass Filter*2 "HPF R"
Front/Rear High Pass "HPF"
Filter*3
Sub woofer Low Pass "LPF SW"
Filter*1
Volume offset "V-Offset"
Loudness "LOUD"
• According to the Bass Q Factor setting value, the
frequencies that can be set in Bass Center Frequency
change as shown below.
Bass Q Factor Bass Center Frequency
1.00/1.25/1.50 60/70/80/100
2.00 60/70/80/150
• When the Bass Extend is set to ON, low frequency
response is extended by 20%.
• Volume offset: Each source's volume can be set as a
difference from the basic volume.
• Loudness: Compensating for low and high tones
during low volume.
• *1 You can control this item when <Switching preout>
(page 23) is set to "SWPRE Sub-W". (KTS-300MR only)
2
• * Function of the KTS-MP400MR
• * 3 Function of the KTS-300MR
Exit Audio Control mode
Press the [AUD] button.
Left 15 — Right 15
Rear 15 — Front 15
–15 — +15
Through/100/125/
170 Hz
Through/200 Hz
Through/100/125/170
Hz
50/80/120/THRU Hz
–8 — ±0
ON/OFF
11
|
English