Transportation; Setting Up; Power Supply; Operation - CombiSteel 7054 Série Mode D'emploi

TRANSPORTATION

Matters to be taken into account during transportation:

Take all required measures to prevent falling and turnover of machine while transportation.

Cut the power supply before transportation.

Avoid hitting and crushing of the machine while transporting.

Use pallet jack or forklift to transport the machine. Do not move it alone if you don`t have such
opportunity. Machine`s centre of gravity is located in the middle of the frame. Pay attention to this point
while moving by pallet, forklift or any other way.

SETTING UP


Set up the appliance on a level surface.

Make sure the appliance is set up properly when operatıng.

POWER SUPPLY


Make sure power supply connection is carried out by qualified personnel.

Make sure that the voltage of your power supply system suits appliance's electrical system.

Do not use the machine if any part of cable or plug is damaged.
Direction of rotation of feeding screw must be the same as it showed on the frame
Machine must be grounded by yellow/green cable and neutralized by blue cable.

OPERATION


Clean the blade and the pan with damp cloth before operating. Dry after cleaning.

Do not operate while empty.

Do not operate machine to process food much less under capacity.

Set up the machine on level surface.

The cover is provided with micro-switch, so the machine will not work while the cover is open.

To start the machine press START button.

To stop the machine press STOP button.

After processing food unplug the machine.
Do not move the machine alone if you don`t have opportunity to transport it
by pallet or forklift. The centre of gravity is in the middle of the frame.
Pay attention to this point while transporting.
Do not transport the appliance by dragging along the ground.
of the machine. If direction of rotation is opposite switch two-phase cable.
(Valid for three-phase models)
The machine is grounded by yellow/green cable.
www.combisteel.com
6