EHEIM BEASTER 180e Manuel D'instruction page 18

EN
See g.IJKL
> DETERGENT SUCTION
See g.M
> HIGH PRESSURE HOSE
Use the hydrocleaner only if the hose is completely
uncoiled and extended.
See g. N
> SWITCHING OFF
T.S. Total Stop
NOTE: Total Stop, which stops the machine
during the bypass phase. To start the water
cleaner, it is therefore necessary to set the switch
on position (I)"ON"; after that press the pistol
trigger: the Total Stop will start the machine
and will stop it automatically when the trigger is
released. It is advisable to put on the safety of the
pistol trigger whenever the machine is stopped,
in order to avoid unintentional starting.
- Any automatic start of the machine without
pressing the gun trigger is attributable to air
bubbles in the water or other similar phenomena
which do not imply the existence of any defects in
the machine.
- Do not leave the appliance unattended during
the standby for more than 5 minutes. Contrarily,
for the safety of the appliance it is necessary to
re-turn the switch into the (0) OFF position.
- Please check that the coupling of the high
pressure hose with the appliance and the gun
supplied as standard equipment made correctly,
that is to say without any water leak.
CARE AND MAINTENANCE
See g. P
The unit is maintenance-free.
25 WARNING: the machine shall be discon-
nected from its power source, by removing the
plug from the socket-outlet, during cleaning or
maintenance
WARNING: Do not spray the appliance with water
and do not use detergents or aggressive solvents.
Machine could be damaged.
18
( if tted)
- Clean the exterior part of the machine with a dry
cloth.
> STORAGE
See g. P
- Move the machine only by grasping the carrying
handle
- Store the appliance and the accessories in a frost-
safe room.
TROUBLESHOOTING
Appliance does not work
- Check whether the voltage shown on the rating
plate corresponds to that of the power source.
- Check the connector cable for damage.
Appliance does not reach operational pressure
- Vent the appliance: allow the pump to operate
without the high-pressure hose until water
appears at the high-pressure outlet without any
more bubbles. Then reattach the high-pressure
hose.
- Clean the strainer in the water connection.
- Clean the lter placed inside the hose coupling (if
set)
- Check the inlet water ow rate.
- Check all inlet pipes to the pump for leaks or
blockage.
Strong pressure uctuations
- Clean the high-pressure nozzle. Remove dirt from
the nozzle hole with a needle and then rinse out
with water from the front.
Pump leaks
- 10 drops per minute are permissible. In the case
of more serious leakage, you should contact the
authorized customer service.
Replacement parts
- Use only original spare parts or spare parts
suggested by the manufacturer.
WARRANTY CONDITIONS
All our machines are subjected to strict tests and are
covered against manufacturing defects in accord-
ance with applicable regulations. The warranty is
e ective from the date of purchase.
The following are not included in the warran-
ty: - Parts subject to normal wear. - Rubber parts,
charcoal, lters and the accessories and optional