Publicité
Les langues disponibles
Les langues disponibles
and couplings are important for the safety
of the machine. Use only hoses, ttings and
couplings recommended by the manufacturer.
(it is extremely important to protect these
components against damage by avoiding their
improper use and protecting them against
bending, knocks and scratches).
09WARNING: Appliances not equipped with
T.S. – Total Stop : must not be left in operation for
more than 2 minutes with the gun released. The
recycled water heats up considerably, seriously
damaging the pump.
10WARNING: Appliances equipped with T.S.–
Total Stop : these appliances should not be left in
standby for more than 5 minutes.
11WARNING: Switch the appliance o
pletely (master switch on (0)OFF) whenever it is
left unattended.
12WARNING: Every machine is tested in its oper-
ating conditions, so it is normal for a few drops of
water to be left inside it.
13WARNING: Take care not damage the electric
cable. If the supply cord is damaged, it must be
replaced by the manufacturer, its service agent or
similarly quali ed persons in order to avoid a haz-
ard
13b WARNING: The power cord should not be
used to pull or lift the machine.
14WARNING: Appliance with uid under pres-
sure. Keep a rm hold on the gun and be pre-
pared to take the kickback pressure. Only use the
high pressure nozzle provided with the appli-
ance.
16WARNING: This appliance is not intended for
use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of
experience and knowledge.
17WARNING: Children should be supervised to
ensure that they do not play with the appliance.
18WARNING: Never start the high-pressure
cleaner without rst completely unwinding the
high-pressure hose.
19WARNING: When winding and unwinding the
pipe take care not to cause the high-pressure
cleaner to overturn.
20WARNING: Before unwinding or winding the
hose, switch the machine o and release the
pressure in the hose itself (switching o ).
21WARNING: Risk of explosion — Do not spray
ammable liquids.
22WARNING: To ensure machine safety, use only
original spare parts from the manufacturer or ap-
proved by the manufacturer.
23WARNING: Do not direct the jet against your-
self or others in order to clean clothes or foot-
wear.
24 WARNING: Water that has own through
back ow preventers is considered to be non-
potable.
25 WARNING: machine must be disconnected
from its power source during cleaning or main-
tenance and when replacing parts or when con-
verting the machine to another function.
26 WARNING: Improper extension cables can be
dangerous. If an extension cord is used, it must
be suitable for outdoor use, and the connection
com-
must be kept dry and clear of the ground. It is
recommended that this be done using a cable
reel that holds the plug at least 60 mm from the
ground.
27 WARNING: If an extension cord is used, the
plug and socket must be of watertight construc-
tion.
28 WARNING: During the use of high pressure
cleaners, aerosols may form. Inhalation of aero-
sols can be dangerous to health.
29 WARNING: Depending on the application,
shielded nozzles can be used for high pressure
cleaning, which will drastically reduce the emis-
sion of hydrated aerosols. However, not all ap-
plications allow the use of such a device. If the
armored nozzles are not applicable for aerosol
protection, a respiratory mask of class FFP 2 or
equivalent may be necessary, depending on the
cleaning environment.
> SAFETY DEVICE
WARNING: the gun is tted with a safety catch.
Whenever use of the machine is interrupted it is
important to operate the safety catch to prevent
accidental activation of the jet.
- Safety features: gun equipped with safety locking
device, appliance equipped with (Class I) over-
load cutout, pump equipped with by-pass valve
or shutdown device.
- The safety button on the gun is not there to lock
the lever during operation, but to prevent its ac-
cidental operation.
WARNING: The appliance is equipped with a mo-
tor protection device: in case of device interven-
tion, wait some minutes or, in alternative, discon-
nect and re-connect the product to the electric
EN
15
Publicité
