EHEIM BEASTER 180e Manuel D'instruction page 17

a quali ed electrician. As the colours of the wires in
the mains lead of this appliance may not correspond
with the coloured markings identifying the termi-
nals in your plug, proceed as follows:
The wires that is coloured Brown must be connected
to the terminal which is marked with the letter L or
coloured Red. The wire that is coloured Blue must be
connected to the terminal which is marked with the
letter N or coloured Black.
Safety points for rewireable or moulded plug:
The mains lead of this appliance may be already
tted with a BS1363 13A plug.
- If your socket outlet is not suitable for the plug,
then the plug must be removed (cut o if it is a
moulded on plug), the exible cord insulation
should be stripped back as appropriate and a
suitable 3 pin plug tted.
an ASTA marked fuse, approved to BS1362, of the
same rating must be used.
- Always replace the fuse cover after tting a fuse.
The plug must NOT be used if the cover is omitted
or lost until a replacement is obtained.
- Make certain that only the correct fuse cover is
used and tted.
- For plugs with detachable fuse cover the
replacement must be the same as the colour
insert in the base of the plug, or as directed by the
embossed wording on the base of the plug.
- If the detachable fuse cover is lost a replacement
may be purchased from a Service Centre.
PUT INTO SERVICE / STARTING
UP
See g. A
- Connect the high pressure hose to the trigger gun.
- Push the high pressure hose into the trigger gun.
WARNING: Dispose
of a plug that has
been cut from
the power supply
cord, as such a
plug is hazardous
if inserted in a live
13A socket outlet
elsewhere in the
house.
- Should the fuse
need to be replaced
Note: Make sure the connection nipple is aligned
correctly.
- Check the secure connection by pulling on the
high pressure hose.
See g. B
- Insert the high pressure hose tightly into the quick
coupling on the appliance
See g. C
- Screw the coupling element to the water
connection on the appliance.
- Attach the water supply hose to the coupling on
the water connection.
NOTE: The supply hose is not included.
- Connect the water supply hose to the water
supply.
- Completely open the water tap.
- Insert the mains plug into the socket.
- Turn on the appliance "I/ON".
See g. D
- Unlock the lever on the trigger gun.
- Pull on the lever of the trigger gun; the device will
switch on.
- Switch the appliance on for a (max. of 1 minute)
and wait until the water exits at the hand spray
gun without bubbles.
- Release the lever on the trigger gun.
NOTE: Release the lever of the trigger gun; the
device will switch o again.
- High pressure remains in the system.
See g. E
- Lock the lever on the trigger gun.
Operation
See g. F
- Push the spray lance into the trigger gun and fasten
it by turning it through 90°.
- Unlock the lever on the trigger gun.
See g. G
- Pull on the lever of the trigger gun; the device will
switch on.
14WARNING: Appliance with uid under pres-
sure. Keep a rm hold on the gun and be prepared
to take the kickback pressure.
See g.H
> HIGH PRESSURE LANCE
EN
17