EHEIM BEASTER 180e Manuel D'instruction page 16

EN
system. In case this problem repeats again or if
the product does not start again, take the product
to the nearest After Sales Service Point
> STABILITY
WARNING:
The machine must be always kept on hori-
zontal bases, in a safe and stable way.
USAGE
> DESCRIPTION OF THE MACHINE
See the speci c instructions manual provided.
> ASSEMBLY INSTRUCTIONS
See the speci c instructions manual provided.
> WATER SUPPLY
Water supply collection
Water supply from the water main
- Connect a supply hose (not included) to the water
inlet of the unit and to the water supply.
- Open the water supply.
WARNING: (symbol) machine not suitable for
connection to the potable water mains.
The cleaner can only be connected to the water
mains if the water mains is separated by a back-
ow preventer. Make sure that the hose is at least Ø
13mm-1/2 inch and that it is reinforced, 5-25 m.
WARNING: Water that has
back ow preventers is considered to be
nonpotable.
IMPORTANT: Only clean or ltered water should
be used for intake. The delivery of the water
intake tap should be equal to the double of the
maximum pump range.
- Minimum delivery rate: 15 l/ min.
- Maximum intake water temperature: 40°C
- Max inlet water pressure: 1Mpa
Place the cleaner as close to the water supply system
as possible.
Water supply from an open container
- Unscrew the coupling part for the water inlet.
- Screw the suction hose with lter (not included)
onto the water connection of the unit.
- Hang the lter in the container.
- Vent the unit before operation.
- Unscrew the high-pressure line at the high-
pressure outlet of the unit.
16
- Switch on the unit and let it run until water free of
bubbles emerges at the high-pressure outlet.
- Switch o the unit and screw on the high-pressure
hose again.
Failure to comply with the above conditions causes
serious mechanical damage to the pump and the
loss of warranty cover.
> ELECTRICITY SUPPLY
- The appliance's electrical connection must
comply with the IEC 60364-1 standard.
appliance, make sure that the nameplate data are
the same as those of the electrical mains and that
the socket is protected by a di erential security
breaker with tripping sensitivity below 0.03 A - 30
ms.
- If the appliance's plug is not compatible with the
socket, have the socket replaced with another of
suitable type by professionally quali ed sta .
- Never use the appliance in ambient temperatures
below 0° C if it is equipped with a PVC (H VV-F)
cable.
- No actions needed for adjusting machines
marked with dual voltage and frequency.
26 WARNING: Improper extension cables can be
dangerous. If an extension cord is used, it must
be suitable for outdoor use, and the connection
must be kept dry and clear of the ground. It is
recommended that this be done using a cable
own through
reel that holds the plug at least 60 mm from the
ground.
27 WARNING: If an extension cord is used,
the plug and socket must be of watertight
construction.
Information for supply may also be obtained
from the plug manufacturer.
<20 m
20 m - 50 m ø 2,5 mm
> PLUG
HOW TO CONNECT THE CORD TO A U.K. PLUG:
IMPORTANT The wires in the mains lead are
coloured in accordance with the following code:
Blue
Brown
Yellow/Green
Please read the instructions given below before con-
necting the cord to a plug. If in doubt please consult
IMPORTANT:
Before
<16 A
ø 1,5 mm - 14 AWG ø 2,5 mm
2
- 12 AWG ø 4,0 mm
2
connecting the
<25 A
- 12 AWG
2
- 10 AWG
2
Neutral
Live
Earth