Linea 2000 DO908DV Mode D'emploi page 33

www.domo-elektro.be
This appliance is designed to function in ambient temperatures between 16°C and
32°C. Should the room temperature exceed this reach, the appliance will not function
correctly. The food may spoil.
In order to obtain a correct operation, the appliance should be installed:
• in a dry area
• out of direct sunlight
• away from extreme temperatures (this also means away from a stove or other heat
sources)
• on a strong, stable floor
Ventilation
Above the freezer, there should be a free, empty space of 50 mm.
If it is not possible to keep a free space above the freezer, then keep a free, empty
space of 25 mm at both sides of the freezer.
Levelling
The freezer needs to be placed completely upright and level, so that it will not rock.
Check if the 2 adjustable legs are firmly on the ground when the freezer is completely
upright and level.
If not, adjust the legs by screwing or them in or out the freezer.
Caution: This appliance is heave. Be careful.
Reversing the door
The freezer is built with the door hinges on the right side. If you want to switch the
direction in which the door opens, follow the following instructions:
1. Remove the cover of the upper hinge (6).
2. Remove the 2 screws (1) that attach the upper hinge (5) to the freezer. Remove
the upper hinge.
3. Lift the door and place it on a soft surface so that it does not get damaged.
4. Remove the 2 screws (8) that attach the lower hinge (2) to the freezer. Remove
the lower hinge.
5. Remove the left front leg (4) and move it to the right side of the freezer.
6. Replace the cover plate (7) to the right side.
7. Before placing the lower hinge (2), remove the bolt (the right leg) (9) en reverse
the direction of the lower hinge. Install the lower hinge at the bottom left of the
freezer with the 2 screws (8).
8. Screw the bolt (9) back into the lower hinge (2).
9. Place the door in its place, on the lower hinge (2).
33
DO908DV