Kohler STERLING 5900 Série Mode D'emploi page 24

Instale el sello de felpa
Instale un buje en uno de los extremos de la guía del panel interior.
Mida la longitud de la guía del panel, reste 1" (2,5 cm) y corte el sello de felpa a
la medida resultante.
Coloque el sello de felpa en la guía del panel.
Instale un buje en el otro extremo de la guía del panel.
Utilice unas pinzas para doblar cada extremo de la guía del panel y así evitar que
los bujes se salgan.
11.
Install the Panel Guide
Bottom Track
Rail inférieur
Carril inferior
Inside Panel Guide
Guide du panneau intérieur
Guía del panel interior
Panel Guide Installed
Guide du panneau installé
Guía del panel instalada
NOTE: Perform these installation steps from inside the shower.
Install the panel guide in the opening of the bottom track.
Align the slots on the panel guide with the holes in the inside panel bottom
frame.
Loosely thread two #8-18 x 3/8" panhead screws through the guide and into the
frame. Do not tighten at this time.
Push the panel guide all the way into the bottom track.
Lower the guide slightly for clearance and tighten the screws.
Move the panel back and forth along the full width of the opening.
If the panel sticks, loosen the screws and adjust the guide. Repeat until the door
operates smoothly.
Install screw covers over the panel guide screws.
1063217-2-J
Inside Panel
Panneau intérieur
Panel interior
#8-18 x 3/8" Panhead Screw
Vis à tête ronde #8-18 x 3/8"
Tornillo de cabeza redonda del #8-18 x 3/8"
24 Sterling