AEG FAVORIT 55000 Notice D'utilisation page 26

26
Installation
3. Lift the worktop and move it from the
front slots (3).
4. Use the adjustable feet to adjust the level
of the appliance.
5. Install the appliance under the kitchen
worktop. Do not squash or bend the water
hoses during the installation.
To adjust the level of the appliance
A correct level of the appliance lets the door to close and seal correctly.
With an incorrect appliance level, the door does catches on the sides of the cabinet.
Loosen or tighten the adjustable feet to make the appliance level.
Water drain connection
Connect the water drain hose to:
• The sink spigot and attach it under the work surface. This prevents that the waste water
from the sink goes back into the appliance.
• A stand pipe with vent-hole. The internal di-
ameter must be minimum 4 cm.
Remove the sink plug when the appliance
drains the water to prevent that the water goes
back into the appliance.
The drain hose extension must not be longer
than 2 m. The internal diameter must not be
smaller than the diameter of the hose.
If you connect the water drain hose to a trap spi-
got under the sink, remove the plastic membrane
(A). If you do not remove the membrane, remain-
ing food can cause a blockage in the drain hose
spigot
A safety device impedes the dirty water to go back
into the appliance. If, the spigot of the sink has a
'non-return valve', this can cause the appliance to
drain incorrectly. Remove the non-return valve.
max 85 cm
min 40 cm