3.
Attach casters
Firmly push casters into holes at corners of dishwasher as
shown. Pull on each caster to check that casters are snug.
HELPFUL TIP: It may be helpful to place a piece of wood
between the caster wheels and then lightly tap the wood with
a hammer.
PREPARE DISHWASHER
WARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
4.
Stand dishwasher upright
Beaded foam
shipping pieces
Stand dishwasher upright. Open door and remove shipping
foam, cardboard tower, and any other shipping materials.
Close dishwasher door. Latch dishwasher door shut.
4
CONNECT DISHWASHER
Connecting the Faucet Adapter
NOTES:
A hose that attaches to a sink spray can burst if it is installed
■
on the same water line as the dishwasher. If your sink has a
spray hose, it is recommended that the hose be disconnected
Caster
and the hole plugged.
A special adapter must be installed on the faucet before the
■
dishwasher can be connected. Complete the instructions
below using the provided adapter.
When moving your dishwasher, make sure the door is latched.
Hold the dishwasher at the top front corners.
5.
Remove the screen holder or aerator, screen, and washer from
the end of the faucet. Use the faucet adapter kit that came
with your portable dishwasher to modify the faucet where the
dishwasher will be used.
NOTE: Remove and save the washer, screen, and screen holder
or aerator for future use.
DETERMINE FAUCET THREAD TYPE
6.
Insert the 2 screens and then the thin washer from the faucet
adapter kit into the faucet adapter. Attach the adapter onto
the end of the faucet.
NOTE: Do not use the thick washer.
Prepare faucet
Washer
Screen
Screen holder
or aerator
Attach faucet adapter –
external threads
Thin washer
Screens
Faucet adapter