Removing The Collected Water; Care And Maintenance; Care And Cleaning Of The Dehumidifier - Comfee MDDF3-16DEN7 Mode D'emploi

OPERATING THE UNIT

Removing the collected water

There are two ways to remove collected water.
1. Use the bucket
When the bucket is full, the Full indicator light
will illuminate, the digital display shows P2.
Slowly pull out the bucket. Grip the left and right
handles securely, and carefully pull out straight so
water does not spill. Do not put the bucket on the floor
because the bottom of the bucket is uneven. Otherwise
the bucket will fall and cause the water to spill.
Throw away the water and replace the bucket. The
bucket must be in place and securely seated for the
dehumidifier to operate.
The machine will restore to its original state when the
bucket is replaced in its correct position.
NOTES:
When you remove the bucket, do not touch
any parts inside of the unit. Doing so may
damage the product. Be sure to push the
bucket gently all the way into the unit.
Banging the bucket against anything or
failing to push it in securely may cause the
unit not to operate.
When you remove the bucket, if there is some
water in the unit you must dry it .
1. Pull out the bucket a little.
Fig.5
2. Hold both sides of the bucket
with even strength, and pull it
out from the unit.
Fig.6
3. Pour the water out.
16
Removing the collected water
2. Continuous draining
Water can be automatically emptied into a
floor drain by attaching the unit with a water
hose(not included).
Remove the rubber plug from the back drain
hose outlet. Attach a drain hose(ID=13.5mm)
and lead it to the floor drain or a suitable
drainage facility(see Fig.7).
Make sure the hose is secure so there are no
leaks.
Direct the hose toward the drain,making sure
that there are no kinks that will stop the warter
flowing.
Place the end of the hose into the drain and
make sure the end of the hose is level or
down to let the water flow smoothly. Do never
let it up.
Make sure the water hose is lower than the
drain hose outlet.
Select the desired humidity setting and fan
speed on the unit for continuous draining to
start.
NOTE: When the continuous drain feature is
not being used, remove the drain hose from
the outlet and reinstall the rubber plug.

Care and cleaning of the dehumidifier

Turn the dehumidifier off and remove the plug
from the wall outlet before cleaning.
1. Clean the Grille and Case
Use water and a mild detergent. Do not use bleach
or abrasives.
Do not splash water directly onto the main unit. Doing
so may cause an electrical shock, cause the insulation
to deteriorate, or cause the unit to rust.
The air intake and outlet grilles get soiled easily, so use
a vacuum attachment or brush to clean.
2. Clean the bucket
Every few weeks, clean the bucket to prevent growth of mold,
mildew and bacteria. Partially fill the bucket with clean water
and add a little mild detergent. Swish it around in the bucket,
empty and rinse.
NOTE: Do not use a dishwasher to clean the bucket.
After clean, the bucket must be in place and securely
seated for the dehumidifier to operate.

CARE AND MAINTENANCE

remove the rubber
plug
Attach the hose
to the drain
hose outlet.
9
17
Fig.7