Identification Of Parts; Positioning The Unit; Operating The Unit; When Using The Unit - Comfee MDDF3-16DEN7 Mode D'emploi

IDENTIFICATION OF PARTS

Identification of par ts
Front
Control panel
1
2 Handle (both sides)
Air outlet grille
3
Water bucket
4
5 Water level window
Rear
1 Drain hose outlet
Caster
2
3
Power Cord and plug
4
Air intake grille
5
Air filter (behind the grill)
Power cord Buckle(Used
6
only when storing the unit.)
NOTE: All the pictures in the manual are
for explanation purposes only. The actual
shape of the unit you purchased may be
slightly different, the actual shape shall
prevail. The operations and functions are
the same.
1
2
3
4
5
Fig.2
4
5
6
1
2
3
Fig.3
14

Positioning the unit

A dehumidifier operating in a basement will have little or no effect in drying an adjacent enclosed
storage area, such as a closet, unless there is adequate circulation of air in and out of the area.
Do not use outdoors.
This dehumidifer is intended for indoor residential
applications only. This dehumidifier should not be used
for commercial or industrial applications.
Place the dehumidifier on a smooth, level floor strong
enough to support the unit with a full bucket of water.
Allow at least 20cm of air space on all sides of the unit
for good air circulation.
Place the unit in an area where the temperature will not
O O
fall below 5 C(41 F). The coils can become covered with
O O
frost at temperatures below 5 C(41 F), which may reduce
performance.
Place the unit away from the clothes dryer, heater or radiator.
Use the unit to prevent moisture damage anywhere books
or valuables are stored.
Use the dehumidifier in a basement to help prevent
moisture damage.
The dehumidifier must be operated in an enclosed
area to be most effective.
Close all doors, windows and other outside openings
to the room.

When using the unit

When first using the dehumidifier, operate the unit
continuously 24 hours.
This unit is designed to operate with a working
O O O
environment between 5 C/41 F and 32 C/90 F, and
between 30%(RH) and 80%(RH).
If the unit has been switched off and needs to be
switched on again quickly, allow approximately
three minutes for the correct operation to resume.
Do not connect the dehumidifier to a multiple socket
outlet, which is also being used for other electrical
appliances.
Select a suitable location, making sure you have easy
access to an electrical outlet.
Plug the unit into a electrical socket-outlet with earth
connection.
Make sure the Water bucket is correctly fitted otherwise
the unit will not operate properly.
NOTE:When the water in the bucket reaches to a certain
level,please be careful to move the machine to avoid it
falling down.

OPERATING THE UNIT

40cm or
more
Air outlet grille
20cm or more
20cm or more
20cm or more
Fig.4
Casters(Install at four points on the
bottom of unit)
Do not force casters to move over
carpet, nor move the unit with water
in the bucket. (The unit may tip over
and spill water.)
NOTE:Casters is optional,some
models without.
O
15
Air intake
grille
20cm or more