Publicité
Les langues disponibles
Les langues disponibles
DO9100W
BATTERY
1 pc of lithium battery 3V cr2032.
Please remove the isolation sheet from the battery contact
before use. Please take note to the polarity.
REPLACING THE BATTERY
open the battery case cover on the back of the scale.
lift the battery out of the compartment and place a new battery by
first placing one side against the positive plate and then pressing
down the other side of the battery.
OPERATION
1. Put the scale on a hard and flat surface to guarantee the
accuracy of the scale. avoid carpet or soft surfaces and make sure that there is
nothing underneath the scale.
2.
gently step on the scale. Put your feet evenly on the scale without moving. The
scale turns on automatically.
3.
wait until your weight shown on the display is stable and locked.
AUTOMATIC SWITCH OFF
when you step off the scale, it will automatically switch off. auto shut-off occurs
approximately 8 seconds after a stable weight is reached.
CHANGE THE WEIGHING UNIT
The scale has the possibility to display the weight in kilo's (kg) or pounds (lb).
1.
Press the button on the bottom of the scale when the scale is
turned on. The current weighing unit will now be indicated on
the display.
2.
Press the button again to change the weighing unit.
OVERLOAD INDICATION
"err" code indicates scale overload.
LOW BATTERY INDICATION
"lo" code is shown when battery power is low. Please install new battery.
ERROR DURING WEIGHING
"c" code is shown when an error occurs during weighing. step back on to the scale to
weigh again.
18
plaque positive
Publicité
