Malfunctions; Disposal; After Sales Service - SATA trueSun Mode D'emploi

Operating Instructions SATA trueSun
EN
■ Keep the LED lamp, battery and charger in a dry place.
■ Check the LED lamp for damage every time after use, repair if neces-
sary.
10.1. Replace protective screen with impact protection
■ Pull the impact protection [2-1] off the LED lamp [2-3] to the front.
■ Remove the protective screen [2-2].
■ Insert a new protective screen in the impact protection.
■ Position the impact protection with screen on the LED lamp applying
gentle pressure until it locks in position.

11. Malfunctions

If it is not possible to remedy a malfunction with the described corrective
actions, send the LED lamp to the SATA customer service department
(address see chapter 15).
Malfunction
LED lamp does not
go on.
LED lamp goes off
unexpectedly.

12. Disposal

Dispose of the LED lamp, battery and charger as recyclable material. To
avoid damage to the environment, dispose of the LED lamp, battery and
charger separately from each other in an appropriate manner. Comply
with local regulations!

13. After Sales Service

For accessories, spare parts and technical support, contact your SATA
dealer.
The battery is guaranteed for max. 6 months. The 1+3 guarantee ruling
applies to the complete product (LED lamp and charger).
68
Cause
Battery completely dis-
charged.
LED lamp overheats.
Power saving cut-out
after 2.5 minutes.
Battery completely dis-
charged.
LED lamp overheats.
Corrective action
Recharge battery.
Cool LED lamp down
(max. operating-
temperature 40 °C).
Switch LED lamp on
again at button [1-4] .
Recharge battery.
Let LED lamp cool
down (max. operating
temperature 40 °C).