Intended Use; Description; Scope Of Delivery - SATA trueSun Mode D'emploi

areas.
■ Keep the LED lamp, battery and charger away from ignition sources
such as naked flames, burning cigarettes or flying sparks.
■ Do not expose the LED lamp, battery and charger to rain and wet con-
ditions.
■ Do not expose the LED lamp, battery and charger to the effects of heat-
ers or direct sunlight.
Technical status
■ Never make any unauthorised modifications or technical changes to the
LED lamp, battery and charger.
■ Never use the LED lamp, battery and charger when damaged or if parts
are missing.
■ Stop using the LED lamp, battery and charger immediately if damaged.
■ Check the LED lamp, battery and charger for damage every time before
use and repair if necessary.
■ Keep the vent slots on the charger free.
Operating parameters
■ Only operate the LED lamp, battery and charger within the parameters
stated on the nameplate.
Cleaning
■ Never use solvents or agents containing solvents to clean the LED
lamp, battery or charger. Always use SATA wet and dry cleaners (Art.
No. 75358) for cleaning.

3. Intended Use

The LED light is used to simulate sunlight when illuminating surfaces for
spraying.

4. Description

The LED lamp is used to illuminate resprayed surfaces. The simulated
sunlight of the LED lamp reveals tiniest differences in the sprayed sur-
face.

5. Scope of Delivery

■ LED lamp
■ Lithium ion battery
■ Charger
■ Operating Instructions
After unpacking, check:
Operating Instructions SATA trueSun
EN
63