Care And Storage; Maintenance And Repairs - SATA trueSun Mode D'emploi

LED 1 [1-12]
green LED flashes
red LED is on permanently
red LED flashes
LED 2 [1-13]
red LED is on permanently
red LED flashes
8.3. Normal Operation
Switch LED lamp on and off
Notice!
Depending on the ambient temperature, the maximum operating time
of the LED lamp is about 60 – 70 minutes. The battery then has to be
charged again. When the battery is completely discharged, charging
takes about 50 minutes.
■ Press button [1-4] and switch the LED lamp on.
■ Use the fully variable dimmer with detent function [1-2] to adjust the
required brightness.
■ When no longer needed, press the button again and switch the LED
lamp off.
Check battery charge status
■ Press the Bat.Info button [1-12] on the back of the battery. The number
of LEDs that light up indicate the current charge state of the battery.

9. Care and storage

Careful handling together with constant care of the product is necessary
to warrant the functioning of the LED lamp.

10. Maintenance and repairs

Operating Instructions SATA trueSun
battery is fully charged
battery is defective
Batteries whose temper-
ature falls below 0 °C or
exceeds 45 °C are not
charged.
charger is connected to
the power grid and is
ready
charger is defective
EN
67