2
4
3
28
7.7,
STEAM DISPENSING.
• Check that the switch (1) is in position "
the pressure inside the steam boiler is 1.2 bar (0.12 MPa)
indicated on the pressure switch(2).
• Turn the steam lance (3) to the bowl and then make a
short supply dispense of steam by slowly turning the
knob (4) counterclockwise to remove any residual water
present in the circuit.
• Remove the steam lance (3) to the outside then put a cup
or a pot full of liquid to be heated under the lance (3).
• Fully immerse the nozzle of the steam lance into
the liquid and slowly open the valve (4) by turning it
counterclockwise.
1
• Once reached the desired temperature close the tap (4).
• Turn the steam lance (3) to the bowl and then make a
short dispensing to clean the inside of the jet and clean
the nozzle (3) with a damp cloth to prevent the fouling
difficult to remove.
ATTENTION: The lance (4) is very hot.
Move the lance only with proper rubber
protection; Danger of scalding.
" and that