Bionaire BPH1414 Manuel D'utilisation page 3

BPH1414-1520-I_IM-REV2.qxd:BPH1515I06MLM1.qxd 4/30/09
ENGLISH
RETAIN THE FOLLOWING FOR
FUTURE REFERENCE.
DESCRIPTIONS (See Fig.1 & 2)
PLEASE READ AND SAVE THESE
IMPORTANT INSTRUCTIONS
WARNING:
WARNING:
CAUTION:
BASE ASSEMBLY (See Fig. 3)
WALL MOUNTING ASSEMBLY
(See Fig. 4 – Fig. 6)
IMPORTANT:
NOTE:
11:03 AM Page 2
Turning the unit on/off and setting the
Digital Thermostat (BPH1520 Only)
NOTE: The mode Indicator Light (E)
will flash in the AUTO mode if the set
temperature is lower than the current
room temperate displayed on the
Display, this is also the same if the
unit has reached the required set
temperature.
NOTE: In Auto mode, it is normal for
the heater to cycle ON and OFF as it
maintains the programmed temperature.
To prevent the unit from cycling, raise
the thermostat setting.
The Digital Thermostat remembers the
previous temperature setting after the
unit is turned off. However, if the unit
is unplugged, the digital thermostat
resets and no longer remembers the
previous temperature setting.
Turning the unit on/off and setting the
thermostat (BPH1414 Only)
PROGRAMMABLE TIMER (BPH1520 Only)
Setting the On Timer:
Setting the Off Timer:
FROST GUARD (BPH1520)
FROST GUARD (BPH1414)
AUTO SAFETY SHUT OFF
The heater has a built in safety device which
will switch off the heater automatically in case
of accidental overheating. It can only resume
operation when the user has reset the unit. For the
BPH1520 (OH) will display in an overheat situation.