Bodum IBIS Mode D'emploi page 6

SAFETY CUT-OFF
The kettle is protected against damage resulting from use
with an insufficient volume of water. A safety cut-off will
automatically disconnect the power supply if the heating
element overheats.
Should the kettle ever boil dry during operation, you must
leave it to cool for 10 minutes before re-filling it with cold
water. The safety cut-off will reset automatically once it has
cooled.
BEFORE USING THE KETTLE
Clean the kettle before using it for the first time by filling it
completely (to the MAX mark) with water, boiling the
water, and then discarding the water.
HOW TO USE THE WATER KETTLE
FILLING THE WATER KETTLE
– Remove the appliance body from the base unit (5).
– Open the lid (1), fill with water and close the lid again.
Do not fill the kettle with less than 0.5l/17oz and not more
than 1.5l/51oz (above the MAX mark), to prevent the kettle
from boiling dry or boiling water escaping from the spout.
CONNECTION TO POWER SUPPLY
– After filling the kettle, position it on the base unit (5).
Ensure that the kettle body is seated correctly on the
contact unit on the base unit (5).
– Connect the mains plug to the power supply and raising
the ON/OFF switch (4).
Note: Ensure that the ON/OFF switch is able to move freely.
SWITCHING OFF
– Your kettle has an automatic ON/OFF switch and will
switch itself off automatically as soon as the water boils.
– You can switch off the kettle at any time by press down
the ON/OFF switch (4).
Note: The kettle cannot be switched off by hand if the
switch is not free to move, or if the ON/OFF switch is pressed
raising.
POURING OUT WATER
– To remove the kettle from the base unit (5), hold it by its
handle. Ensure that the kettle body remains level while
lifting it from the base unit (5).
– Pour the water from the spout with the lid (1) closed.
Note: Please take care when pouring out water as boiling
water can cause scalds.
5