In Combination With Central Unit; Installation - Watts BT-TH02 RF Manuel D'utilisation

4. IN COMBINATION WITH
CENTRAL UNIT

4.1 Installation

If your thermostatic head works in com-
bination with a RF Central Unit, it will
become a remote unit.
To configure your thermostatic head with
the BT-CT02 RF (Central Unit (1)):
• Press and maintain the ( ) key during 5s,
then you are in the Parameters Menu
number 10. Press the RIGHT key ( ) to
be in the RF pairing mode (User Menu
number 11).
• Now put your Central Unit in RF pairing
mode too. (please refer to the Central
Unit leaflet for this) The Central Unit will
now send the radio configuration signal
(2) to the thermostatic head.
• After few seconds, the Central Unit and
the thermostatic head should exit by
themselves the RF pairing mode, this
is the normal procedure to confirm a
correct pairing.
• Now, you can check the RF distance and
if RF signal is strong enough, replace
the Central Unit to its room. Return
14
** To ease the installation, it will be better to
have the Central Unite near to the thermo-
static head during the configuration mode.
(A minimal distance of > 1 meter must be
respected)
> 1 m
2
to your room where the thermostatic
head is placed. Put your thermostatic
head in Comfort mode (setting tempera-
ture position 30°C), wait the backlight
extinction and 5 seconds more (RF
antenna will blink during RF communica-
tion on the LCD).
• Now return to the Central Unit to see
the setting passes through the RF and
is also equal to 30°C in the Central Unit.
If the RF signals were received correctly,
adjust your setting temperature as you like.
ENGLISH
EN
1