Reversible Door - Blomberg WSN 1412 LT Mode D'emploi

Reversible door

The door can be changed from right-hinged to left-hinged and vice versa as
follows:
1. Lay the appliance on its
back and loosen the upper
hinge.
4. Carefully remove the
covers on the side of the
plinth using a flat-headed
screwdriver.
7. When the lock pin has
been loosened completely,
pull it up together with the lock
cylinder and refit on opposite
side.
10. After reversing the door, it is important to check that the sealing strip provides a tight seal all
the way round. If it does not, carefully heat the strip all the way round using a hair dryer. Then
ease the strip outwards slightly so that it forms a tight seal against the cabinet. Be careful not to
heat the strip so much that it melts!
2. Remove the upper hinge.
5. Pull up the hinge pin...
...and fit it on the opposite
side.
8. Click the covers into place
on the plinth sides on the
opposite side.
7
3. Rotate the glass door
through 180° (on WSN 1412
LT, pull the handle to loosen it
on the inside from beneath the
sealing strip).
6. Unscrew the lock pin using
a flat-headed screwdriver.
9. Fit the door onto the bottom
pin, fit the top hinge and
tighten securely.