Cd Read Setting; Firmware Version Display; Demonstration Mode Setting - Kenwood KDC-X491 Mode D'emploi

Menu system
In Standby mode

CD Read Setting

When there is a problem with playing a CD with
special format, this setting plays the CD by force.
Display
"CD READ1"
"CD READ2"
⁄
• Some music CDs may not play even in the "CD READ2"
mode.
In Standby mode

Firmware Version Display

Displaying the firmware version with the unit.
1
Select the firmware version display mode
Push the Control knob towards up or down.
Select the "F/W VER" display.
2
Display the firmware version
Push the Control knob towards right or left.
In Standby mode

Demonstration Mode Setting

Sets the demonstration mode.
1
Select the Demonstration mode
Push the Control knob towards up or down.
Select the "DEMO" display.
2
Set the Demonstration mode
Press the Control knob for at least 2 seconds.
Each time you press the knob at least 2 seconds,
the Demonstration mode alternates between the
settings shown in the table below.
Display Setting
"DEMO ON" The Demonstration mode function is ON.
"DEMO OFF" Exit Demonstration mode (Normal mode).
26
|
English
Setting
Play CD and Audio file.
Play CD by force.