Touch Sensor Tone; Manual Clock Adjustment; Dsi (Disabled System Indicator); Display Illumination Control - Kenwood KDC-X491 Mode D'emploi

In Standby mode

Touch Sensor Tone

Setting the operation check sound (beep sound)
ON/OFF.
Display Setting
"BEEP ON" Beep is heard.
"BEEP OFF" Beep canceled.
In Standby mode

Manual Clock Adjustment

1
Select Clock Adjustment mode
Push the Control knob towards up or down.
Select the "CLK ADJ" display.
2
Enter Clock Adjust mode
Press the Control knob for at least 1 second.
The clock display blinks.
3
Adjust the hours
Push the Control knob towards up or down.
Adjust the minutes
Push the Control knob towards right or left.
4
Exit Clock adjustment mode
Press the [MENU] button.
In Standby mode

DSI (Disabled System Indicator)

A red indicator will blink on the unit after the
faceplate is removed, warning potential thieves.
Display Setting
"DSI ON" LED flashes.
"DSI OFF" LED OFF.

Display Illumination Control

This function turns off the display when you
perform no operation for 5 seconds. This function is
effective when you are driving at night.
Display Setting
"DISP ON" Keeps the display on.
Turns off the display when you perform no
"DISP OFF"
operation for 5 seconds.
⁄
• Set the Display Illumination Control when the
<Demonstration mode Setting> (page 26) is set to OFF.
• When the display is off, pressing any key will turn on the
display.
• When the display is off, you cannot perform any
operation except for the following:
• Volume
• Attenuator
• Selecting the source
• Ejecting the disc
• Turning off the power
• During function control, such as the Menu System, the
display stays on.
In Standby mode

Dimmer

Dimming this unit's display automatically when the
vehicle light switch is turned ON.
Display Setting
"DIM AUTO" The display dims.
"DIM OFF" The display doesn't dim.
23
|
English