Schneider Airsystems SEM 100-8-6 W-oilfree Notice D'utilisation D'origine page 8

GB
SEM 100-8-6 W-oilfree
1.5 Components
01 Compressor unit
02 Intake filter
07 Check valve
08 Vessel
09 Condensate drain valve
10 Pressure switch with ON/OFF switch
11 Safety valve
12 Pressure gauge (vessel pressure)
14 Electric motor
15 External protective motor switch
18 Pressure reducer
19 Quick-action coupling
1.6 Maintenance
1.6.1 Cleaning the intake filter
1. Remove the filter insert cover.
2. Pull out the filter insert. (Fig. 5a)
3. Clean the filter insert using the blow gun,
exchange the filter insert if necessary.
4. Insert the filter insert, push the cover
shut.
1.7 Compressor inspections
Special inspections are not required for this
compressor.
We recommend that a "qualified person" per-
form a pressure test on the vessel after 10
years, depending on general levels of wear
and tear.
I/4
A "qualified person" should be well informed
about Ordinance on Industrial Safety and
Health (formerly authorised expert)
Contact any of our approved service part-
ners. Most of our service partners have em-
ployees with expert qualifications.
The papers accompanying the vessel are
approval documents and must be kept
throughout the service life of the vessel.
These specifications only apply in Germa-
ny. Equivalent regulations apply in other
countries.
1.8 EC Declaration of Con-
formity
Compressor
SEM 100-8-6 W-oilfree
Year of CE mark: 2008
We declare under sole responsibility that this
product complies with the following direc-
tives and standards:
98/37/EC (up to 28.12.2009); 2006/42/EC
(from 29.12.2009); 97/23/EC (module A);
87/404/EEC; 2000/14/EC;
2006/95/EC; DIN EN ISO 3744 / 12100; DIN
EN 1012 / 60204-1 / 55014-1 / 286-1, EN
61000-3-2, -3-3, -3-11.
pp Marco Lodni
Head of Development/Testing
08.2008
Schneider Druckluft GmbH
Ferdinand-Lassalle-Str. 43
72770 Reutlingen
Serial no.
A343002
2004/108/EC;