Keso Mozy Eco Power Unit; Low-Voltage Power Unit - KESO MOZY eco Manuel D'utilisateur

EN – User Manual KESO MOZY eco
Step 4 - Figure D
Fasten the KESO MOZY eco with the screws supplied. Check once again that
the key moves freely in the KESO MOZY eco. The KESO MOZY eco must not
turn stiffly or suddenly.
Step 5 - Figure E
- Feed the cable from the sensor under the motor and connect it correctly to
screw terminal X6. The Magnet-Contact has to be measured by a Digital-
Multimetre (Ohm). There has to be found the switching contact. (I.e. Picture
J Cable 1+4)
- Screw terminal X6: terminal 3 = door contact (TK);
Terminal 2 = external bolt contact (RK) and terminal 1 = plus.
- Couple the main KESO MOZY eco cable to connector X5.
Note Model V2:
1 GND
2 RKIN
3 TKIN
4 red
5 red
6 green
7 green
Note:
1+2 external bolt contact
1+3 Door Contact / Reed- Contact
4-7 Max. contact load 110 VAC/DC 1A
potential free contacts for generating the red (4,5) and green (6,7) LED
signal.
10/2008
Step 6 - Figures F / G / H
Connect the power unit and program the KESO MOZY eco before fitting the
casing. On fitting the casing, be sure to keep a distance of 0.5 mm between the
KESO MOZY eco casing and the turn knob.
4.3.

KESO MOZY eco Power Unit

4.3.1.

Low-Voltage Power Unit

The power unit has two 10-pin connectors (J1/J2) which must be coupled as
shown in the diagram opposite side of the page. The main cable is to be con-
nected to terminals J1/1 to J1/6 in the order of the colours shown in the dia-
gram.
1
1
2
2
3 3
4
4
5
6
5
7
6 8
7
suject to change without notice Page 33 from 48 pages