Design And Function; Design; Motor-Driver Cylinder; Power Unit - KESO MOZY eco Manuel D'utilisateur

EN – User Manual KESO MOZY eco
3.

Design and Function

3.1.

Design

3.1.1 Motor-Driven Cylinder
The motor-driven cylinder consists of a base plate onto which the control
electronics and the gear unit are screwed. The casing and the turn knob snap
onto the base plate to seal off the electronic and mechanical components.
In addition to the control electronics, the printed circuit board contains the
connection terminals for the main cable, the door contact and the program-
ming jumpers / switch.
3.1.2

Power Unit

Power is supplied and signals are transmitted via the main cable which runs
from the power unit to the KESO MOZY eco. The three-conductor mains cable
is wired to the mains.
WARNING!
Do not open the power unit. Risk of electrocution!
10/2008
3.2

Description of the Functions

3.2.1

KESO MOZY eco Jumper Configuration / Model V1

Basic Jumper Configuration
The functions are configured by using jumpers. The factory configuration is as
follows: door locking to the left, standard lock with latch bolt, learning mode
deactivated.
The table below shows all the combinations that can be obtained with the
jumpers (see Figure F – Jumper positions V1)
Jumper Open
position
O O J1 Door locking to left
O O J2 Standard lock
O O J3 With latch bolt
O O J4 Spare
O O J5 Spare
O O J6 Spare
O O J7 Learning deactivated
"Panic" Function Jumper
Jumper J2 must be closed if a panic lock is used. Make sure that the internal
lock contact is connected to terminal X6/2 (RK) and X6/3 (GND) (see Figure E).
suject to change without notice
Closed
Door locking to right
Panic lock
Without latch bolt
Spare
Spare
Spare
Learning activated
Page 29 from 48 pages