Assembly; Operation - Ryobi D Série Manuel D'utilisation

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance. In Mexico, please call 01-800-843-1111.
WARNING:
Do not allow familiarity with products to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict severe injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
APPLICATIONS
You may use this product for the purposes listed below:
 Numerous applications are available depending upon the
accessory head installed.
TO INSTALL/REMOVE BATTERY PACK
See Figure 2, page 9.
To install:
 Lock the switch trigger on the tool by placing the direc-
tion of rotation (forward/reverse/center lock) selector in
center position.
 Place battery pack in the tool. Align raised rib on battery
pack with the groove inside the tool.
 Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.

OPERATION

WARNING:
Always remove battery pack from your tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
To remove:
 Lock the switch trigger on the tool by placing the direction
of rotation selector in center position.
 Depress latch on back of battery pack and pull battery
pack away from tool to remove.
WARNING:
Battery products are always in operating condition.
Therefore, the switch should always be locked when not
in use or carrying at your side.
VARIABLE SPEED SWITCH TRIGGER
See Figure 3, page 10.
The variable speed switch trigger delivers higher speed with
increased trigger pressure and lower speed with decreased
trigger pressure.
To turn the tool ON, depress the switch trigger. To turn it
OFF, release the switch trigger and allow the tool to come
to a complete stop. The trigger will not operate the power
base unless an accessory head is attached.
NOTE: A whistling or ringing noise coming from the switch
during use is a normal part of the switch function.
LED LIGHT
The LED light, located above the switch trigger, illuminates
when the switch trigger is depressed. This provides extra
light for increased visibility.
5 – English