Publicité
Les langues disponibles
Les langues disponibles
U S E R G U I D E
G1200/G1201
Installation
1
The gate must be installed in a
structurally sound opening. Never install
between two railings or two stair posts.
Ensure mounting surface (wall, doorframe,
etc.) is strong, rigid and is smooth, clean
and grease free. If mounting onto brick,
drywall or other surfaces, an optional gate
installation kit, wooden board mounted to
the surface or additional hardware may be
necessary to provide a solid, smooth
surface. Measure opening to determine if
extensions are needed. Correct width will
be reached by adjusting all 4 corner
spindles. Each spindle adjusts individually
and may be extended to varying lengths
(up to 1 ¾" each) to allow for molding,
uneven walls, etc. This gate can be used
in a closed doorway. Never use gate at top
of stairs
2
Spindle attachment is different
when using extensions and when not
using extensions. If no extension/s are
used, slide top spindles (a) and bottom
spindles (c) into spindle housing end (b).
Push assembly into gate corners.
3
If using extension/s (see Extension
Placement Guide) insert square extension
tubes (f) into gate ends. Connect extension
bar (g) to one upper extension housing (d)
and one lower extension housing (e).
Push assembly over extension tubes.
There should be no metal showing from
extension tubes. It may be necessary to
apply pressure to tubes to ensure they are
fully inserted into gate ends. Slide top
spindles (a) and bottom spindles (c) into
extension tubes.
4
Extra Tall and Wide Auto Close Gateway
1
1
2
2
(a)
(b)
(a)
(b)
(c)
(b)
(c)
(b)
3
3
G1200/G1201
®
4
4
5
5
(b)
(a)
(b)
(a)
(b)
(c)
(b)
(c)
6
6
(f)
(d)
(a)
(g)
(c)
(f)
(e) (c)
Extra Tall and Wide Auto Close Gateway
4
Spindle housings are not used if square
extension tubes are required. If the
housings have been inserted, remove with
a screwdriver.
5
Center the gate in opening with bottom
rail resting on floor. Gaps on each side
should be equal. IMPORTANT: The gate
must be level and straight up and down,
otherwise the gate's self closing door will
not function properly.
6
Pull out the two bottom spindles (c)
until they touch the mounting surface and
rest on top of floor molding (if applicable).
Tighten handwheels TOWARD GATE
FRAME as tightly as possible. Each spindle
adjusts individually and may be extended
to varying lengths to allow for molding,
uneven walls, etc.
(c)
U S E R G U I D E
®
5
Publicité
