Publicité
Les langues disponibles
Les langues disponibles
3. Remove the high efficiency filter and in-
stall the foam filter (see "Removing/Install-
ing the Filter"). Ensure that the float cage
remains in place.
4. A float cage shuts off suction when the tank is full.
Be sure that the float is clean and moves freely in
the float cage to ensure that the float valve works.
5. Plug in the vacuum.
6. Turn on the vacuum and begin pick-up.
7. Turn off the vacuum immediately upon completing
a wet pick-up job or when tank is full and ready to
be emptied. If suction shuts off, turn off the vacuum
immediately and empty the tank.
8. Unplug the vacuum.
9. To empty the tank, raise the hose to drain any
excess liquid into the tank. Do not use vacuum
inlet to drain contents.
10. Remove motor housing and pour liquid waste into
a suitable drain.
11. Clean the interior of the tank and pick-up acces-
sories periodically, more often when used to pick
up wet, sticky materials. Use warm, soapy water.
Do not store vacuum with liquid in tank.
Automatic Suction Shut-Off
When picking up liquids, an internal float rises until it
seats itself against a seal at the intake of the motor,
shutting off suction. When this happens, the motor
will develop a higher than normal pitch noise and the
suction is drastically reduced. If this occurs, turn off
the vacuum immediately.
NOTICE
Failure to turn off unit after float
rises and shuts off suction will re-
sult in damage to the motor.
To continue use, empty the liquid waste from the tank.
If the vacuum is accidentally tipped over, it could lose
suction. Turn off the vacuum and return it to an upright
position. The float will return to its normal position.
Installing/Removing Fleece Dust Bag
For increased filter life and ease of cleanup, use a
fleece dust bag to collect fine dust particles (Single
pack, Cat. No.'s 49-90-1979, 49-90-1989, 49-90-
1999).
Float cage
1. To install, release the tank latches and remove
the motor housing.
2. Lift the dust bag holder up and out to remove
from the tank.
3. Slide the cardboard dust bag inlet in to the dust
bag holder.
4. Insert the dust bag holder back into the slot push-
ing downward to secure in place.
5. Spread out the dust bag in the tank. Replace the
motor housing and secure both latches.
6. To remove, release the tank latches and remove
motor housing.
7. Lift the dust bag holder up and out to remove
from the tank.
8. Slide the dust bag holder off the dust bag.
9. Pull the cardboard tab until the dust bag inlet
is closed. Dust bag is now sealed and can be
properly disposed.
Replace fleece dust bag once the bag is at full ca-
pacity, suction decreases or dust bag is damaged.
Before storing your vacuum, empty and clean the
tank, filter, and accessories. Unplug the vacuum.
6
Storage
Publicité
