Comet HOT BOX Série Mode D'emploi page 26

• Perform the checks required by routine maintenance.
• The equipment must be protected against freezing: if it is not possible to protect this way, before starting
it, take it to a warm environment for long enough to melt any ice inside. Failure to do so could cause
serious damage to the equipment.
• If the equipment is used above 1000 m/3281 ft of height, contact a SKILLED TECHNICIAN for a check
and a possible combustion adjustment.
• The use of agricultural, heating or dirt diesel fuel causes excessive deposits onto the burner, thus impairing
its good operation.
• After use, before performing the "STOP" procedure, run the equipment with the burner off for a few
minutes so as to cool down the delivery circuit.
Make sure that the product purchased consists of the following elements:
• mobile boiler;
• high-pressure connection hose to the combined high-pressure cleaner;
• instruction book;
• rotating coupling (27) for connecting to the high-pressure cleaner M22x1,5 (HOTBOX 25/350 only);
• water outlet fitting M22x1,5 (29) (HOTBOX 25/350 only);
• declaration of conformity;
• warranty certificate;
• booklet giving the service centres.
If there are any problems, contact the Manufacturer or an authorized service centre.
• Using a 22 mm/0.86 in hexagon spanner, tighten the coupling (26) to the fixed coupling (25) (HOTBOX
25/350 only). Operation C in Fig. 5.
• Using two 22 mm/0.86 in hexagon spanners, replace the coupling (22) with the coupling (27) (HOTBOX
25/350 only with combined high-pressure cleaner with max pressure up to 200 bar/2900 psi). Operation B
in Fig. 5.
WARNING
• The following operation must only be performed by a SKILLED TECHNICIAN.
• Contact a SKILLED TECHNICIAN to replace the fitting (28) with the fitting (29) (HOTBOX 25/350 only
with combined high-pressure cleaner with max pressure up to 200 bar/2900 psi). Operation E in Fig. 6.
• Connect the coupling (23) to the coupling (24), tightening well (HOTBOX 25/500 only). Operation D
in Fig. 5.
• Making reference to the indications in the relative instruction manual, take the combined high-pressure
cleaner to the workplace and engage any parking brake.
• Move the equipment to the workplace by means of the handlebar (2). If fitted, engage the brake (15) of
the swivel wheel (14).
• Making reference to the indications in the relative instruction manual, connect the combined high-pressure
cleaner to the water supply.
• Completely unwind the high-pressure hose (21) connecting the combined high-pressure cleaner to the
equipment and the delivery hose (32) of the high-pressure cleaner.
• Connect the high-pressure hose (21) to the outlet of the combined high-pressure cleaner. Operation F
in Fig. 7.
• Connect the delivery hose (32) of the combined high-pressure cleaner to the equipment outlet.
Operation G in Fig. 7.
• Making reference to the indications in the relative instruction manual, connect the spray gun to the
26
STANDARD EQUIPMENT
INSTALLATION - FITTING ACCESSORIES
OPERATION - PRELIMINARY ACTIVITIES