• After moving the equipment, remember to always engage the braking device, if fitted.
• Carefully read the instructions and warnings on the labels of the detergents to be used and store them
in a safe place out of children's reach.
In case of contact with eyes, immediately rinse with water. In case of swallowing, do not induce vomit:
immediately contact a doctor, and show him/her the pack of detergent.
• WARNING. Any cleaning, maintenance, replacement of parts and conversion of the equipment for other
functions must only be done after performing the operations described in the "STOP" section, in perfectly
stable conditions (if fitted, always engage the braking device) and once the equipment has fully cooled
down.
In particular, always remember to disconnect the combined high-pressure cleaner and the equipment
from their power supply sources.
• When the equipment is left to cool down, take care:
- not to leave it unattended in the presence of unsupervised children, elderly or disabled people;
- that it is in a stable position and not at risk of falling over;
- to engage the braking device, if fitted;
- not to place it in contact with inflammable materials, or in their immediate vicinity.
• To clean, do not use thinners or solvents.
• WARNING. To ensure the safety of the equipment, only use genuine spare parts supplied by the
Manufacturer or approved by it.
• WARNING. The high-pressure hoses, accessories and fittings are important for the equipment's safety.
Only use high-pressure hoses, accessories and fittings that are recommended by the Manufacturer.
• Special maintenance jobs must only be performed by a SKILLED TECHNICIAN.
• In the event of not being able to restore the correct operation of the equipment with the aid of the
information contained on the table "TROUBLESHOOTING", contact a SKILLED TECHNICIAN.
• Before scrapping the equipment, make it unusable, for example by cutting the power cable and render
harmless those parts that could be hazardous for children playing with the equipment.
• If fitted, the battery is a component part with a strong environmental impact and it must not be disposed
of together with household wastes. For further instructions, contact your local waste disposal service or
dealer.
• Use only diesel fuel for motor driving.
• WARNING. Do not use unsuitable fuels to avoid dangerous situations.
• WARNING. It is important that ventilation is such as to ensure the exhaust gases are eliminated in an
appropriate way.
• WARNING. Make sure the exhaust emissions are not close to the air inlets.
• Never cover the boiler exhaust gas outlet.
• Never bend onto the exhaust gas outlet, nor touch it with bare hands (burn hazard).
• During the filling/topping-up operations of the diesel fuel, pay attention not to pour it onto the equipment.
In case this happens, wait at least 24 hours before restarting the equipment, so that the liquid that has
possibly entered the device can evaporate.
CAUTION
• Refer to the table of the "SPECIFICATIONS AND TECHNICAL DATA" section and as regards the water
supply, make sure the max and min temperatures and max pressure are correct. In case of any doubt,
contact a SKILLED TECHNICIAN.
• Do not operate the equipment:
- if it is not connected to a water supply;
- with salt water or water containing impurities: in this event, run the equipment for a few minutes with
clean water;
- if it is too noisy and/or large quantities of water are dripping below it;
- if it is directly exposed to sunrays, with ambient temperature above 40 °C .
• In case of operation at very low temperatures, make sure there is no ice inside the pipes.
HINTS ON PROPER USE
Strong chance of damaging the equipment if the following indications
are not complied with.
EN
25