IKAR DB-A3 Mode D'emploi page 14

6. Adjustable rubber feet:
The rubber feet feature a fold-away
design for better adaption to ground
conditions.
The horizontal position (Illus. 10) is
recommended for hard and stable
ground.
The vertical, tip-standing position is
recommended for softer ground (Illus. 11)
in order to prevent slipping
7. Optional accessories:
IKAR fall protection device HRA with
rescue lifting gear:
The IKAR fall protection device HRA with
rescue lifting gear is attached to the leg
bearing the type plate with the fixture.
Mount the fixture (Illus. 12, 13 and 14) to
the leg in a way that enables the safety
staff to ergonomically operate the rescue
lifting handle. The proper clamping force
of the fixture is obtained through the
length (45.8mm) of the included spacing
sleeves.
The fastening torque of the hexagon
screws M 10 x 75, quality 8.8 is 49Nm.
The locking bar must be positioned ac-
cording to the device size. The fastening
torque of the cylinder-head bolts M 8 x
40, quality 8.8 is 40Nm. Insert the IKAR
HRA device into the fixture. The IKAR
HRA device is secured with a locking pin.
Attention: Only mount IKAR fixtures.
Only IKAR devices may be mounted in
IKAR fixtures.
The 3 integral deflection rollers (Illus. 15)
serve for guiding and redirecting the steel
rope of the IKAR fall arresting device
HRA and/or other ropes, e.g. of the
personnel winch PLW.
Note: The IKAR HRA device retracts the
rope automatically as long as the rescue
lifting function is not engaged.
ENGLISH
.
Illus. 10
Illus. 12
Illus. 15
14
Illus. 11
Illus. 13
Spacing sleeve
M 10 x 75
Position HRA 9,5-12
Position HRA 15-18
M 8 x 40
Position HRA
24, 33, 42
Locking bar