Clatronic KA 2426 Mode D'emploi page 18

30439-05-KA 2426/2427
Electrical Connection
GB
• Make sure that the machine is switched off (operating switch on "OFF").
• Before inserting the mains lead into the socket, check whether the voltage you
intend to use complies with that of the machine.
For details see the machine label.
• Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
Operation for models without a timer
1. Pull the lid of the water tank forwards. Fill the machine to the level corresponding
to the number of cups required with cold water.
2. Place a paper filter (size 1 x 4) into the filter funnel and fill it with coffee powder
(approx. 1 teaspoon for 2 cups).
3. Place the pot on the hot plate and close the lid of the water tank.
4. Move the switch to the "EIN/1" position. The coffee takes approximately 10 - 15
minutes to boil. When no more coffee is running into the pot it can be removed.
If you would like to keep the remaining coffee warm, the switch must remain in the
"EIN/1" position. The hot plate will keep the coffee warm until you switch the machi-
ne "AUS/0".
Switching Off
The machine is switched off when the switch is in the "AUS/0" position.
Operation for models with a timer
Items 1 – 3 are identical for models without a timer.
4. Press the "ON/OFF" button. The indicator light comes on. The coffee takes
approximately 10 - 15 minutes to boil. When no more coffee is running into the
pot it can be removed.
Set time/timer (models with timer)
The clock shows a flashing "0:00" if it has not been set.
Setting the time: Hold down "MIN" or "HOUR" for 3 seconds until the colon (:)
appears. Set the time with the buttons. The unit quits the time-setting mode if 5
seconds passes without a button being pressed. The colon continues to flash.
Setting the timer: Do the same as when setting the time in order to set the time
when the unit switches on automatically. Hold down "MIN" or "HOUR" and also the
"PROGRAM" button for 3 seconds. Next you must activate the timer.
Activating/Deactivating the timer
Press the "PROGRAM" button. The timer is activated if a clock symbol appears on
the display.
18
04.05.2001 8:33 Uhr Seite 18