Delta 46-455 Manuel D'instructions page 9

SPUR AND LIVE CENTERS
To reduce the risk of injury, tighten all
screws and levers securely when adjusting any part
of the lathe.
To reduce the risk of injury, be sure
the taper on the spur center (G) is clean before
mounting to the headstock spindle.
ATTACHING SPUR CENTER
NOTE:
REMOVING THE SPUR CENTER
To reduce the risk of injury, when
removing the centers, use a soft cloth to protect
against the sharp edge.
NOTE:
ATTACHING LIVE CENTER
REMOVING THE LIVE CENTER
To reduce the risk of injury, when
removing the centers, use a soft cloth to protect
against the sharp edge.
Q
O
P
Fig. 8
G
Fig. 5
K
Fig. 6
H
Fig. 7
F
Fig. 9
F
G
H
G