Programme Progress - Hotpoint Ariston TCD G51 XB Notice D'utilisation Et Installation

The Display

Programme progress

GB
The second line of the display shows the status of the programme as it progresses:
(long messages scroll across the line)
DRY
COOL TUMBLE
END OF CYCLE, CREASE CARE
END OF CYCLE, CLEAN FILTER AND EMPTY WATER BOTTLE
Timed drying
Each press reduces the time duration and number of available time options depending on the programme/material
selected.
The Timed Dry icon
The selected time remains displayed after the programme starts, but can be changed anytime you wish.
Delay and Time to End
Some programmes can have a delayed start (see Start and Programmes). Press the
Each press of the Delay button
in 1 hour increments, from:
then after a couple of seconds cancels the delay.
The delay time is shown on the display next to the Delay button.
The display counts down the minutes of the delay period after
the Start/Pause button
The second line of the display shows
You can change or cancel the delay time selected anytime if
you wish.
After the Start/Pause button is pressed the Delay or Time to End is displayed in hours and minutes and counts down each
minute.
Time to End
After the delay period finishes, or for all the programme if delay not selected:
- the estimated time to the end of the programme, for automatic programmes or the actual time remaining during a
timed programme is shown in this part of the display.
When timed programmes are selected the time displayed throughout the cycle is the actual time remaining.
When Automatic programmes are selected the time displayed is an estimate of the time remaining. When the
programme is selected the display shows the time required to dry a full load, after around 10 minutes the controller
calculates a better estimate of the cycle time and this is updated during the programme.
The colons between the hours and minutes in the display flash to show the time is counting down.
24
(if option Post Care selected).
is displayed next to the time.
advances the delay setting
1h to 24h , then OFF
is pressed.
STARTS IN
After selecting a programme that has a Timed Dry option,
press the Timed button and the display will increment the
selected time, each time you press and release the button
(see Start and Programmes).
and
Delay button and the icon flashes.