Residual Risks; Initial Start-Up; Assembling/Dismantling The Two-Piece Blow Tube - FLORABEST FLS 3000 B2 Traduction Des Instructions D'origine

Additional safety instructions:
• After they have been joined to-
gether, the blower tubes cannot
be taken apart again!
• Switch off the device before
installing or removing the collec-
tion bag.
Recommendation:
Connect the device, as far as pos-
sible, only to a plug socket with
a ground-fault circuit interrupter
(g.f.c.i switch), with a rated residu-
al current at not more than 30 mA.

RESIDUAL RISKS

Even if properly operating and hand-
ling this electric tool, some residual
risks will remain. Due to its construc-
tion and build, this electric tool may
present the following hazards:
a) Ear damage if working without
ear protection.
b) Damage to your health caused
by swinging your hands and
arms when operating the appli-
ance for longer periods of time
or if the unit is not held or main-
tained properly.
c) Lung damage, if suitable respi-
ratory protection is not worn.
d) Eye injuries if no suitable eye
protection is worn.
Warning! During operation,
this electric tool generates an
electromagnetic field which,
under certain circumstances,
may impair the functionality
of active or passive medical
implants. To reduce the risk of
serious or lethal injuries, we
recommend that persons with
medical implants consult their
doctor and the manufacturer
of their medical implant befo-
re operating the machine.

Initial start-up

Before operating the equipment, you must
- install the blower or suction pipes,
- install the collection bag for suctioning
leaves,
- install the protective cover (suction intake)
for blowing leaves.
Caution, Risk of Injury! Du-
ring the assembly or disas-
sembly of the blower pipe,
suction pipe, protective cover
or collection bag, the engi-
ne must be turned off and
all moving parts must have
come to a standstill.
Always disconnect the plug
from the mains socket before
working.
Assembling/dismantling the
two-piece blow tube
Never use the leaf blower
with only one blower tube
section attached. There is a
risk of personal injury!
1. Assemble the two-piece blow
tube (9) as illustrated. The parts
can be felt to lock into place.
During assembly, make sure that
the groove on the upper section
of the blower tube is inserted
into the recess provided on the
lower section of the blower tube.
GB IE
29