Velleman PSSE10 Mode D'emploi page 4

3. Determine the polarity of the unit. The polarity of the device can
be found on the device or in its manual.
4. Select a proper adapter plug and plug it into the DC input jack of
the device.
5. Plug the adapter into the mains.
6. Disconnect after use.
Note
If the unit does not operate properly, check the polarity setting
immediately.
5. Technical Specifications
supply voltage .......................... 100-240 V~, 50/60 Hz
power .............................................................. 12 W
max. output current ..................................... 1000 mA
7 selectable output voltages ...................... 3 to 12 VDC
plugs .................... 2.5 mm - 3.5 mm - 2.1 x 5.0 mm –
....................... 2.5 x 5.5 mm - 1.35 x 3.5 mm –
......................... 1.7 x 4.0 mm - 0.75 x 2.35 mm
additional plugs ........................................ PLUSPSET1
cable length .................................................... 1.7 m
Use this device with original accessories only. Velleman nv
cannot be held responsible in the event of damage or injury
resulting from (incorrect) use of this device. For more info
concerning this product and the latest version of this manual,
please visit our website www.velleman.eu. The information in
this manual is subject to change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or
otherwise without the prior written consent of the copyright holder.
V. 01 – 22/08/2016
PSSE10
4 ©Velleman nv