Imetec F2015 Mode D'emploi page 17

overheat protection system to activate.
• Do not fold or bend the wired areas, as these actions could result in
activating the over heat protection system.
SWITCHING THE THROW ON AND SELECTING THE CORRECT
TEMPERATURE
The control unit has 6 temperature settings:
: temperature to pre-heat the throw
1-5: temperatures for continuous use
• Turn on the throw from the back of the control unit by positioning
the switch ON 'I' (11).
• EXPRESS FAST PRE-HEAT - Press the Express pre-heat button on the
front of the control unit (7). The Express led
IMPORTANT: The time required to heat the throw may vary depending
on the room temperature. To judge the temperature accurately, lie
on your sofa with the throw draped over you. Do not rely on a hand
placed on the throw.
• CONTINUOUS USE - For continuous use, set the control unit on
temperatures from 1 to 5 pressing the temperature selector (8) until the
desired led lights up (5). The higher the selected number, the higher the
temperature.
For continuous use, set the control unit to temperature
levels 1 to 5 only.
DO NOT set the control unit to a higher temperature
than recommended for continuous use.
If the control is set to a higher temperature the user may
suffer skin burns or heat stroke
WARNING!
or under the sheets when in use.
• If you wish to switch your throw off, simply press the timer button (6). The
standby led (9) will light up in blue.
DO NOT place the control unit under the pillow
(5) will light up in red.
EN
16