Troubleshooting/Repair - Nikon COOLSHOT PRO STABILIZED Mode D'emploi

„ Troubleshooting/Repair
„
If this product fails to function as expected, check the list below before consulting your local dealer or the
store where you purchased it.
l If there is a problem with the product.
Problem
• Does not turn on
• Unable to measure
• Anomalous result
• Cannot see the internal display
• Difficult to see the internal display
• Do not know if STABILIZED
function is working
• Cannot turn off the STABILIZED
function
• There are minute motion
sounds when the power turns
on and off
• [ ] is displayed in the internal
display
• Press the PWR button (top of the body).
• Check that the battery is inserted correctly.
• Replace the battery with a new one.
• Confirm the settings.
• Confirm if it can measure a large target close to you (example: a building
approx. 15 m/yd. ahead of you).
• Clean the lens surface if necessary.
• Check the brightness of the internal display, and adjust it as necessary.
Cover the objective lens so that checking the internal display is easier.
• Compare the vibration of the target in the viewfinder when the Laser
Rangefinder is ON and OFF.
• While the Laser Rangefinder is ON, the STABILIZED function is always
activated.
• The STABILIZED function is activated concurrently when the Laser
Rangefinder is ON. When the Laser Rangefinder is OFF, the STABILIZED
function automatically turns off.
• The STABILIZED function cannot be turned on or off manually.
• Due to the STABILIZED system motor, minute motion sounds occur.
These sounds are normal, please continue to use the Laser Rangefinder.
• Failure indication. Please contact your local dealer or the store where you
purchased the product.
Cause/Solution
En
Es
Fr
De
It
Sv
Nl
Ru
Pb
Pl
Fi
No
Dk
Cz
Ro
Hu
23