Clatronic BS 1236 Mode D'emploi page 42

5....-05-BS 1236
4. Remove the filter inserts (see illustrations G and H) and clean the filters by
GB
tapping and brushing out gently. You can use the cleaning brush (26) to help
you.
5. Re-insert the components. Lock the lid of the dust container again. See illu-
stration I.
• Every third time that the filters are emptied, or in the case of severe soiling,
clean the filters by allowing water to flow through them against the direction in
which the air blows.
• The filters should only be re-inserted when they are completely dry!
3. Outlet filter:
• The device also has two exhaust filters.
• We recommend cleaning these filters every fifth time they are emptied.
• These filters are to be found behind the ventilation grid (4) of the front panel (3).
See illustration J.
• Remove the filters and clean them as described above.
Cleaning
• Pull the plug out of the socket before cleaning!
• Clean the casing with a dry cloth.
• Clean the motor protection filter approximately every 3. time the vacuum cleaner
is emptied. Clean the filter in hot water without additives. Put it back into place
only once it is completely dry.
Storage
• Move the handle to a vertical position (a). See illustration E.
• Wind the cable completely.
This device has been tested according to all relevant current CE guidelines,
such as electromagnetic compatibility and low voltage directives, and has been
constructed in accordance with the latest safety regulations.
Subject to technical changes without prior notice!
42
05.03.2004 10:41 Uhr
Cleaning and storage
Seite 42