Installation And Connections; Installation Of The Unit - Hitachi CMP5000WXE Manuel Utilisateur

Installation and Connections

Installation of the Unit

Installation using the optional HITACHI stand or
installation bracket
÷ Please be sure to request installation or mounting of this unit
or the installation bracket by an installation specialist or the
dealer where purchased.
÷ When installing, be sure to use the bolts provided with the
stand or installation bracket.
÷ For details concerning installation, please refer to the
instruction manual provided with the stand or installation
bracket.
Installation using accessories other than the
HITACHI stand or installation bracket (sold
separately)
÷ When possible, please install using parts and accessories
manufactured by HITACHI. HITACHI will not be held
responsible for accident or damage caused by the use of parts
and accessories manufactured by other companies.
÷ For custom installation, please consult the dealer where the
unit was purchased, or a qualified installer.
b hole
a hole
b hole
b hole
CAUTION
To avoid malfunction, overheating of this unit, and possible fire
hazard, make sure that the vents on the main unit are not
blocked when installing. Also, as hot air is expelled from the air
vents, be careful of deterioration and dirt build up on rear surface
wall, etc..
CAUTION
Please be sure to use an M8 (Pitch = 1.25 mm) bolt. (Only this
size bolt can be used.)
8
En
Air vents (fan)
b hole
Center line
b hole
Rear view diagram
Wall-mount installation of the unit
This unit has been designed with bolt holes for
wall-mount installation, etc.. The installation holes that
can be used are shown in the diagram below.
÷ Be sure to attach in 4 or more locations above and
below, left and right of the center line.
÷ Use bolts that are long enough to be inserted 12 mm to
18 mm into the main unit from the attaching surface for
both a holes and b holes. Refer to the side view
diagram below.
÷ As this unit is constructed with glass, be sure to install
it on a flat, unwarped surface.
Center line
a hole b hole
12 mm to 18 mm
CAUTION
Because this unit weighs about 40 kg and the lack of depth
makes it fairly unstable, please use 2 people or more when
packing, carrying or installing.
CAUTION
This unit incorporates a thin design. To ensure safety if vibrated
or shaken, please be sure to take measures to prevent the unit
from tipping over.
Attaching surface
Installation
bracket, etc..
a hole
Main unit
Bolt
12 mm to 18 mm
Bolt
b hole
Side view diagram