Prowork PSB 401/1 Mode D'emploi page 11

Anleitung PSB 401-1 SPK 1 Prowo
GB
1.0. Layout (Fig. 1/2)
1. Machine base
2. Pillar
3. Fixing screw
4. Drill table
5. Clamping screw
6. Machine head
7. V-belt
8. Motor
9. Grip knobs
10. Scroll chuck
11. Spindle
12. Mounting holes
13. Hinged chip guard
14. Depth stop
15. Tightening screw
16. Screw
18. On switch
19. Off switch
20. Grub screw
2.0. Items supplied
b Pillar drill
b Ring gear drill chuck
b Drill chuck key
b Hinged chip guard
b Drill table
3.0. Proper use
This pillar drill is designed for drilling metal, plastic,
wood and similar materials. It is intended for use in
the private sector only.
Food and harmful materials may not be processed
with the machine. The drill chuck is designed solely
for the use of drill bits and tools which have the
stipulated shaft diameter and for cylindrical tool
shanks. The machine is intended for use by adults
only. It is designed for temporary operation (S2 15
min). Any use of the machine other than that which is
cited in these operating instructions releases the
manufacturer from all liability and renders every
warranty claim null and void.
4.0. Safety information
The pillar drill was designed in such a way so as to
all but eliminate potential hazards when the machine
is properly used. However, there are a few safety
precautions to observe in order to ensure that all
residual hazards are ruled out.
Ensure proper voltage
The voltage must comply with the specifications on
02.06.2004 11:03 Uhr Seite 11
the rating plate.
Use a socket-outlet with earthing contact
The device may only be operated from an outlet with
the properly installed earthing contact.
Extension cable
The cord cross section of an extension cable must
measure at least 1.0 mm_. Always completely
unwind a cable reel prior to use. Check the cable for
defects.
Protection against electrical shock
Keep the device away from moisture. The device
must neither be damp nor be operated in a humid
environment. Prior to every use, check the device
and the mains cable with plug for damage. Avoid
bodily contact with earthed parts e.g. pipes, hot
elements, etc.
Protection against fire and explosion
There are spark producing components inside the
device. Do not use the device in the vicinity of
combustible liquids or gases. Otherwise there is a
risk of fire or explosion.
Handle the device with care
Do not use the cable to pull the plug out of the
socket. Protect the cable from heat, oil and sharp
edges. Keep your tools sharp and clean so that you
can work efficiently and safely. Follow the
maintenance regulations and the instructions for
changing tools.
Wear suitable work clothes and personal
protection equipment
Loose clothing is not suitable, as it can be caught by
moving parts, causing you to become entangled.
Wear a hair net if you have long hair. As a general
rule, jewelry should not be worn when working with
machine tools. Ensure that you wear safety goggles.
Not doing so could result in eye injury.
Keep your work area neat and tidy
Disorder in the work area can easily lead to
accidents. Do not leave any tools, objects, or cable in
the direct vicinity of the work area, as this poses a
tripping hazard! Ensure that there is sufficient
lighting.
Watch out for other persons
Watch out for other persons (especially children)
when using the device, and keep them away from
GB
11