FujiFilm WP-FXF500 Mode D'emploi page 53

5
With the camera dismounted, make sure that there are no water
droplets or foreign particles on the O-ring, close the waterproof case
and turn the open/close knob in the direction of "CLOSE" arrow to seal it
tight (pg.10). Wash it thoroughly with fresh water once again.
6
Carefully wipe off the water droplets from the waterproof case.
7
Open the waterproof case a little and dry it in a breezy place out of
direct sunlight. After drying the case, store it where it will not be directly
exposed to sunlight.
Try to remove any remaining salt by lightly
moving the various buttons under the
water.
We recommend soaking it in fresh water
for about 1 hour.
If stored with drops of salty water on it,
salt crystals will clog the movement of
the open/close knob and other parts.
Rusting may also be caused.
When closing the waterproof case, take
care not to catch your fingers or palm in
the waterproof case.
Use a soft, lint-free piece of cloth or
something similar.
Remove the water droplets from under
the Shutter button, the open/close knob
and the others.
Do not use a hair dryer, warm or hot air,
or direct sunlight to dry the waterproof
case.
EN-21