Sinmag Europe SM 120A Mode D'emploi page 4

ENG
SPECIFICATION
Flour Capacity (Kg)
Dough Capacity (Kg)
Power (Kw)
Net Weight (Kg)
Bowl (mm) Ø x depth
Dimension (mm) LxWxH
REMARK: SM120A and SM200A share the same transportation, installation
operation and components of machine.
2. TRANSPORTATION
A. Check encasement to see if there is any damage before unpacking the
case.
B.
After unpacking the top and sides of wooden case, use strong nylon rope
to tie to the four rings as shown in figure 2. Then lift the machine from the
bottom wooden board and move it to the installation position.
Pay attention that the head will not tilt and fall down to prevent oil leakage.
The machine should be placed slowly and steadily.
3. INSTALLATION
1.
Install the machine on a horizontal and plain floor to maintain its appear-
ance and make its wiring in a good condition for long.
2.
Make sure that the bottom plate of the machine is parallel with the floor, if not,
you can adjust it by adjusting leveling screws as shown in Figure 3. (remark:
4
SM120A
75
120
9
0,75
1300
Ø775X419
1600X780X1230
figure 2
SINMAG EUROPE BVBA
SM200A
125
200
12
1,5
1350
Ø960x517
720X980X1430