Télécharger Imprimer la page

senya SYBF-CM008 Notice D'utilisation page 22

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
5. After finish making coffee, take out the funnel by turning clockwise, then hold the filter with
the funnel hook to pour out the coffee residue.
6. Wash the funnel holder and filter with fresh water after cooling completely, clean the
removable shelf and drip tray by using wet cloth.
User-defined coffee brewing time:
After the appliance is preheated, press the single cup button or double cup button for 3 seconds to
enter setting mode. At this time, the indicator light flashes, press the flashing button once, and the
pump starts to working. when the time you need is reached, press this button again to stop, the
program will automatically record the time your preset.
1. The preset time of the single cup is 15-45 seconds.
2. The preset time of the double cup is 30-90 seconds.
3. The double cup preset time is always twice the single cup, so you only need to set one of
them.
4. Keep press the double cup button and steam button for 3 seconds, then two indicator lights
flash three times,preset time will be cleared and the default time will be restored.
III.2.2 MAKE CAPPUCCINO/FROTHED MILK
Cappuccino is made of espresso + foamed milk, So you need to make espresso follow above at first,
and the following content mainly describes the process of milk foaming.
1. Prepare espresso first with container big enough according to the part "MAKE ESPRESSO",
make sure that steam control knob is at the OFF position"
2. Press the steam button,the steam indicator light flashes, the indicates that the coffee machine
enter the steam preheating state. If the steam indicator light is on, it indicates that the
preheating is complete.
3. Fill a jug with about 100ml of milk for each cappuccino to be prepared, recommended to use
whole milk at refrigerator temperature.
Note: In choosing the size of jug, it is recommended the diameter is not less than 70±5mm, and
bear in mind that the milk increases in volume by 2 times, make sure the height of jug is enough.
4. Turn on the steam knob counterclockwise direction, steam comes out,and spray remaining
hot water, then turn the knob clockwise to the closed state when there is no water drops flow
out.
Note: Never turn steam control button rapidly, as the steam will accumulate rapidly within short
time which may increase a potential risk of explosion.
5. Insert foam device into the milk about two centimetre, Slowly turn the steam knob to the
maximum position, froth milk in the way of moving the jug round up and down.
Note:The foam device shall not be placed on the surface of the milk so as not to be scalded.
6. When the required result is reached, turn steam control knob to OFF position.
7. Pour the frothed milk into the espresso prepared, now the cappuccino is ready. You can also
add the right amount of sugar or cocoa powder on top according to your taste.
".
21

Publicité

loading