Salvis 620 Série Traduction Du Mode D'emploi D'origine page 16

Temperature control:
The desired temperature can be set over the electronic controller (see picture 2
electronic controller). In case none of these buttons are pressed, the digital
display shows the current value (room temperature).
When pushing button "SET" the rated value is displayed and you may check if the
right temperature is set.
If you now wish to adjust the rated value, push button "SET" first, than set the
desired value by button "UP" or "DOWN". This rated value is adjustable within the
factory given limits only.
In case of power failure or as the case may be device switch off, the pre-set
values are kept.
Picture 2: Electronic controller
LED LED
alarm evaporator
fan
Defrost
Overview of buttons and operation of electronic controller
To switch device on/off, press button for approx. 2 seconds.
Pressing this button leads to menu „INFO", button „SET" gives
access to ask for the following information.
LED
compressor
LED Button
ECO
LED Button
ECO SET
Button up +
manual defrost
16
Button down+ Button
Horn off Info
Button
ON/OFF