Salvis 620 Série Traduction Du Mode D'emploi D'origine page 14

1. GENERAL INFORMATION
Congratulation! You have bought a high quality refrigerator/freezer. All models
are under permanent quality control. Please read carefully the following
instructions for use. This will allow a trouble free and long lasting operation.
Series HKMN / HKMT / AHKMN / AHKMT:
Upright refrigerator with aggregate, built-in cooling system, ready to plug-in,
evaporator-free cooling compartment.
Series HKON / HKOT / AHKON / AHKOT:
Upright refrigerator without aggregate, for connection to a central cooling system,
evaporator-free cooling compartment.
Please refer to our price list and catalogues for details of our various models
regarding dimensions, gross capacity, accessories, etc.
Attention!
Please check the unit immediately at delivery. In case of transport damages ask
the driver to confirm it on your delivery note as well as on his forwarder's
documents.
2. INSTALLATION AND INITIAL OPERATION
2.1 Installation
If possible, unpack the unit only at its final location, remove plastic film, check
completeness of accessories and damage free delivery. Inform supplier
immediately in case of any reclamation.
Install the unit at a well-ventilated location. Avoid placing it next to heat sources
or direct sunlight. Make sure that a good air circulation is given on top of the unit.
The space between the upper edge of the body and the ceiling must be at least
20 cm. Compensate floor unevenness by using the height-adjustable feet.
Attention!
In order to guarantee a proper operation, the unit must imperative be adjusted
horizontally with a spirit level.
To avoid condensation, the device must be installed with 50 mm distance
away from the walls and other equipments. Urgently needed in series
configuration.
14