Basic Maintenance - VITRA V-Care Manuel De L'utilisateur

Basic maintenance

How to apply decalcification cycle
A
B
C
D
Place WATER GUARD between the seat and WC. (A)
Press WATER TEMP+SEAT TEMP
the remote control for 3 seconds to start Decalcification.
(A single beeping sound will start from this moment)
Nozzle will be extracted. Then water will be dumped
through the nozzle into the bowl for 20 seconds.
When water dumping stops, (B) open the Decalcification
cover and (C) insert funnel through the opening.
(D) Pour the entire decalcification solution into the funnel
slowly and remove the funnel when pouring is finished,
close the cover.
(A double beeping sound will start from this moment)
Wait for about 3 minutes. During this time, the
decalcification solution will soften the calcium build-up
within the tank.
After 3 minutes up, V-Care Prime will perform the following;
3 cycles each of 40 seconds of REAR WASHING + 40
seconds of FEMALE WASHING + 40 seconds of
NOZZLE CLEANSING.
(A single beeping sound will start from this moment)
Nozzle retracts to its' original position and
decalcification is concluded. Remove the water guard.
(The beeping sound stops) The complete descaling
process does not take longer than 10 minutes.
•
Do not pour more than one bottle (125 ml)
!
decalcification solution inside the product
for one decalcification cycle.
•
Clean remaining water on the product after
decalcification cycle with a soft cloth.
•
Do not use sharp objects for opening
decalcification hole cover.
•
Decalcification cycle must be applied every
four months (3 times) in a year.
•
Please clean the funnel with water before
decalcification cycle application to prevent
dust, dirt etc.
•
Do not use any liquid other than the Durgol
descaling agent supplied with the product.
44
+ buttons on
EN