Dometic CoolMatic CR Série Instructions De Montage Et De Service page 15

CRD0050
7.1 Installing the refrigerator
A
NOTICE!
• Fasten the refrigerator as described in the operating manual to
prevent hazards.
• Keep objects clear of openings in the housing or mounting structure
(such as ventilation slots).
• The refrigerator is only suitable for installation in a fitted niche. Once
it is installed, only the front of the refrigerator may be accessible.
• If brakes are applied fully, then strong forces act in the direction of
travel. In order to prevent damage to the refrigerator and the vehicle
interior, the refrigerator should not be installed with the front facing
the direction of travel.
The refrigerator is designed for ambient temperatures between +16 °C and +38 °C.
In continuous operation, the air humidity may not exceed 90 %.
Set up the refrigerator in a dry, sheltered place. Avoid placing it near heat sources
such as radiators, gas ovens, hot water pipes etc.
Install the refrigerator so that the warm air produced can easily flow away (either
upwards or to the sides). Therefore make sure there is adequate ventilation (fig. 3,
page 4).
No. in
fig. 3, page 4
1
2
3
4
The condensation which forms during normal operation of the refrigerator can be
drained off via two outlets on the refrigerator. For delivery purposes, these outlets
are sealed. The two outlets are located on the rear and on the underside of the
refrigerator (fig. 4, page 4).
➤ Choose the condensation outlet most suitable for the place of installation and
remove its cap.
➤ Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the outlet to
pierce open the inside of the refrigerator.
EN
Explanation
Cold intake air
Hot waste air
Condenser
Spacing above the refrigerator if insufficient air can circulate above
or at the side
Installing and connecting the refrigerator
15