Reconfiguring The Cocking Lever; Mounting The Grip - Hämmerli LUFTPISTOLE AP20 Mode D'emploi

5.2.3 Reconfiguring the cocking lever

1 Cocking lever grip
2 Cocking lever
3 Guide pin
4 Fastening screw cocking lever
• Loosen setscrew fixation of the rear sight (2, see image page 19) with the SW2 hexagonal
screwdriver and pull off the rear sight rearward.
• For a left-mounted cocking lever loosen and remove the fastening screw (4) with the hexagonal
screwdriver; mind the mounted spring disk between lever and screw head.
• Remove cocking lever (2).
• Loosen and remove the fastening screw (6) on the cocking lever grip (1).
• Unscrew cocking lever grip and fasten with the screws once again to the cocking lever.
• Attach the cocking lever to the right side of the system housing (5) and fasten with the spring
disk and screw.
Adjust the protrusion of the guide pin (3) to the cocking lever guide track.
• Loosen the setscrew in the loading pins with the SW2 hexagonal screwdriver over the backside
of the system housing.
• Press the guide pin (3) to the right until the pin point protrudes out from the cocking lever guide
track.
• Tighten the setscrew (7) in the loading pins.
• Lightly oil the guide pin in the cocking lever guide track.
• Press the rear sight onto the guide, adjust and fix with the setscrew.

5.2.4 mounting the grip

Insert and adjust the barrel pins (the position of the slit indicates the direction of the setscrew).
• Attach the grip and screw in and tighten the fastening screw (6, see the image on page 15).
Adjust the hand rest and palm rest (see Chapter 5.1.1 / 5.1.2).
1 2 3
6
17
4
5
5 System housing
6 Fastening screw cocking lever grip
7 Setscrew loading pins / guide pin
DE
7
EN
ES
FR